HEIDENHAIN TNC 620 (73498x-02) ISO programming - Manual (Page 463)

Program run 16.5
16
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
463
Running a part program
Preparation
1 Clamp the workpiece to the machine table.
2 Set the datum
3 Select the necessary tables and pallet files (status M).
4 Select the part program (status M).
You can adjust the feed rate and spindle speed with
the override knobs.
It is possible to reduce the feed rate when starting
the NC program using the FMAX soft key. The
reduction applies to all rapid traverse and feed rate
movements. The value you enter is no longer in
effect after the machine has been turned off and
on again. In order to re-establish the respectively
defined maximum feed rate after switch-on, you
need to re-enter the corresponding value.
The behavior of this function varies depending on the
respective machine. Refer to your machine manual.
Program Run, Full Sequence
Start the part program with the machine START button
Program Run, Single Block
Start each block of the part program individually with the
machine START button