HEIDENHAIN TNC 620 (73498x-02) ISO programming User Manual
Page 41
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
41
17.9
Ethernet interface................................................................................................................................. 486
Introduction.............................................................................................................................................486
Connection options................................................................................................................................ 486
Configuring the TNC.............................................................................................................................. 486
17.10 Configure HR 550 FS wireless handwheel........................................................................................ 492
Application.............................................................................................................................................. 492
Assigning the handwheel to a specific handwheel holder.................................................................... 492
Setting the transmission channel...........................................................................................................493
Selecting the transmitter power............................................................................................................ 493
Statistical data........................................................................................................................................ 494