beautypg.com

HEIDENHAIN TNC 620 (73498x-02) ISO programming User Manual

Page 24

background image

Contents

24

TNC 620 | User's Manual for DIN/ISO Programming | 5/2013

6

Programming: Programming contours........................................................................................ 175

6.1

Tool movements................................................................................................................................... 176

Path functions........................................................................................................................................ 176

Miscellaneous functions M.................................................................................................................... 176

Subprograms and program section repeats.......................................................................................... 176

Programming with Q parameters.......................................................................................................... 176

6.2

Fundamentals of Path Functions........................................................................................................177

Programming tool movements for workpiece machining...................................................................... 177

6.3

Approaching and departing a contour...............................................................................................180

Starting point and end point.................................................................................................................. 180

Tangential approach and departure........................................................................................................ 182

6.4

Path contours - Cartesian coordinates...............................................................................................184

Overview of path functions................................................................................................................... 184

Programming path functions..................................................................................................................184

Straight line in rapid traverse G00 Straight line with feed rate G01 F................................................... 185

Inserting a chamfer between two straight lines....................................................................................186

Corner rounding G25..............................................................................................................................187

Circle center I, J.....................................................................................................................................188

Circular path C around circle center CC................................................................................................ 189

Circle G02/G03/G05 with defined radius............................................................................................... 190

Circle G06 with tangential connection...................................................................................................192

Example: Linear movements and chamfers with Cartesian coordinates............................................... 193

Example: Circular movements with Cartesian coordinates................................................................... 194

Example: Full circle with Cartesian coordinates.................................................................................... 195

6.5

Path contours – Polar coordinates..................................................................................................... 196

Overview................................................................................................................................................ 196

Zero point for polar coordinates: pole I, J............................................................................................. 197

Straight line in rapid traverse G10 Straight line with feed rate G11 F....................................................197

Circular path G12/G13/G15 around pole I, J.......................................................................................... 198

Circle G16 with tangential connection................................................................................................... 198

Helix........................................................................................................................................................199

Example: Linear movement with polar coordinates.............................................................................. 201

Example: Helix........................................................................................................................................202