HEIDENHAIN iTNC 530 (60642x-03) ISO programming - Manual (Page 88)

88 Introduction
2.5 Windo
w manag
e
r
Task bar
The task bar that can be shown by pressing the left Windows key on
the ASCII keyboard enables you to select different workspaces with
the mouse. The iTNC provides the following workspaces:
 Workspace 1: Active mode of operation
 Workspace 2: Active programming mode
 Workspace 3: Manufacturer's applications (optionally available), e.g.
remote control of a Windows computer
In the task bar you can also select other applications that you have
started together with the TNC (switch for example to the PDF viewer
or TNCguide)
Click the green HEIDENHAIN symbol to open a menu in which you can
get information, make settings or start applications. The following
functions are available:
 About Xfce : Information on the Windows manager Xfce
 About HEROS : Information about the operating system of the TNC
 NC Control : Start and stop the TNC software. Only permitted for
diagnostic purposes
 Web Browser : Start Mozilla Firefox
 Diagnostics : Available only to authorized specialists to start
diagnostic functions
 Settings : Configuration of miscellaneous settings
 Date/Time : Set the date and time
 Language : Language setting for the system dialogs. During startup
the TNC overwrites this setting with the language setting of MP
7230
 Network : Network setting
 Reset WM-Conf : Restore basic settings of the Windows Manager
May also reset settings implemented by your machine
manufacturer
 Screensaver : Settings for the screen saver; several are available
 Shares : Configure network connections
 Tools : Only for authorized users. The applications available under
Tools can be started directly by selecting the pertaining file type in
the file management of the TNC (see "Additional tools for
management of external file types" on page 136)