HEIDENHAIN iTNC 530 (60642x-03) ISO programming - Manual (Page 52)

52 First steps with the iTNC 530
1
.3 Pr
ogr
amming the first par
t
1.3 Programming the first part
Selecting the correct operating mode
You can write programs only in the Programming and Editing mode:
 Press the operating modes key: The TNC switches to
the Programming and Editing mode
Further information on this topic
 Operating modes: See "Programming and Editing" on page 75
The most important TNC keys
Further information on this topic
 Writing and editing programs: See "Editing a program" on page 105
 Overview of keys: See "Controls of the TNC" on page 2
Functions for conversational guidance Key
Confirm entry and activate the next dialog
prompt
Ignore the dialog question
End the dialog immediately
Abort dialog, discard entries
Soft keys on the screen with which you select
functions appropriate to the active state