HEIDENHAIN iTNC 530 (60642x-03) ISO programming - Manual (Page 498)

498 Manual operation and setup
14.6 Using t
o
uc
h-pr
obes
14.6 Using touch-probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Please note that HEIDENHAIN grants a warranty for the
function of the touch probe cycles only if HEIDENHAIN
touch probes are used!
Function Soft key Page
Calibrating the effective length Page 503
Calibrating the effective radius Page 504
Measuring a basic rotation using a line Page 508
Setting the datum in any axis Page 512
Setting a corner as datum Page 513
Setting a circle center as datum Page 514
Setting a center line as datum Page 515
Measuring a basic rotation using two
holes/cylindrical studs Page 516
Setting the datum using four
holes/cylindrical studs Page 516
Setting a circle center using three
holes/cylindrical studs Page 516