HEIDENHAIN iTNC 530 (60642x-03) ISO programming - Manual (Page 16)

New functions in v
e
rsion 60642x
-02
16
 Improvements to the global program settings (GS):
 All the form data can now be set and reset under program control
(see "Technical prerequisites" on page 374)
 Handwheel superimposition value VT can be reset when tool is
changed (see "Virtual axis VT" on page 382)
 If the Swapping Axes function is active, it is now permitted to
position to machine-based positions on the axes that have not
been swapped
 Improvements to the tool table TOOL.T:
 Using the FIND ACTIVE TOOL NAMES soft key you can check
whether identical tool names are defined in the tool table (see
"Editing tool tables" page 180 ff)
 The input range of the delta values DL, DR and DR2 have been
increased to 999.9999 mm (see "Tool table: Standard tool data"
page 173 ff)
 The following additional functions are now available in the expanded
tool management (see "Tool management (software option)" on
page 195):
 Importing of tool data in CSV format (see "Importing tool data" on
page 200)
 Exporting of tool data in CSV format (see "Exporting tool data" on
page 202)
 Marking and deleting of selectable tool data (see "Deleting marked
tool data" on page 202)
 Inserting of tool indices (see "Operating the tool management" on
page 197)
 New Cycle 225 ENGRAVING (see User’s Manual for Cycle
Programming)
 New Cycle 276 CONTOUR TRAIN (see User’s Manual for Cycle
Programming)
 New Cycle 290 INTERPOLATION TURNING (software option, see
User’s Manual for Cycle Programming)
 In the thread milling cycles 26x a separate feed rate is now available
for tangential approach to the thread (see User’s Manual for Cycle
Programming)
 The following improvements were made to the KinematicsOpt
cycles (see User’s Manual for Conversational Programming):
 Newer, faster optimization algorithm
 It is no longer necessary to run a separate measurement series for
position optimization after angle optimization
 Return of the offset errors (change of machine datum) to the
parameters Q147-149
 More plane measuring points for ball measurement
 Rotary axes that are not configured are ignored by TNC when
executing the cycle