HEIDENHAIN iTNC 530 (60642x-03) ISO programming - Manual (Page 517)

HEIDENHAIN iTNC 530 517
14.9 D
a
tu
m set
ting with a t
o
uc
h pr
obe
Measuring the workpiece with a touch probe
You can also use the touch probe in the Manual Operation and El.
Handwheel operating modes to make simple measurements on the
workpiece. Numerous programmable probe cycles are available for
complex measuring tasks (see User's Manual for Cycles, Chapter 16,
Checking workpieces automatically). With a touch probe you can
determine:
 Position coordinates, and from them,
 Dimensions and angles on the workpiece
Finding the coordinates of a position on an aligned workpiece
 Select the probe function by pressing the
PROBING POS soft key
 Move the touch probe to a position near the touch
point
 Select the probe direction and axis of the coordinate.
Use the corresponding soft keys for selection
 To start probing, press the NC Start button
The TNC shows the coordinates of the touch point as reference point.
Finding the coordinates of a corner in the working plane
Find the coordinates of the corner point: See "Corner as datum—
without using points that were already probed for a basic rotation" on
page 513. The TNC displays the coordinates of the probed corner as
reference point.