HEIDENHAIN iTNC 530 (60642x-03) ISO programming User Manual
Page 12
Chang
e
d functions in v
e
rsion 60642x
-0
1 since the pr
edecessor v
e
rsions
34049x
-05
12
Changed functions in version
60642x-01 since the predecessor
versions 34049x-05
Opening and editing of externally created files has been added (see
"Additional tools for management of external file types" on page 136)
New functions in the task bar have been added (see "Task bar" on
page 88)
Enhanced functions for configuration of the Ethernet interface (see
"Configuring the TNC" on page 575)
Improvements regarding functional safety FS (option):
General information on functional safety (FS) (see "General
information" on page 485)
Explanation of terms (see "Explanation of terms" on page 486)
Checking the axis positions (see "Checking the axis positions" on
page 487)
Activating feed-rate limitation (see "Activating feed-rate limitation"
on page 489)
Improvements regarding the general status view of a TNC with
functional safety (see "Additional status displays" on page 489)
The new HR 520 and HR 550 FS handwheels are supported (see
"Traversing with electronic handwheels" on page 473)
New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks)
3-D line graphics is now also possible in full-screen mode (see "3-D
line graphics (FCL2 function)" on page 154)
A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see "Calling any
program as a subprogram" on page 265)
DCM: Saving and restoring of fixture situations
DCM: The form for test program generation now also contains icons
and tooltips (see "Checking the position of the measured fixture" on
page 364)
DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired (see "Operating
FixtureWizard" on page 361)
DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
DCM: A library with standard chucking equipment is available now
(see "Fixture templates" on page 360)
DCM: Tool carrier management (see "Tool carrier management
(DCM software option)" on page 369)
In the Test Run mode, the working plane can now by defined
manually (see "Setting a tilted working plane for the test run" on
page 550)