HEIDENHAIN iTNC 530 (340 422) - Manual (Page 8)

8
„ New LIFTOFF column in the tool table to automatically remove tool
from the contour after an NC stop (see “Tool table: Standard tool
data” on page 154). Function is activate with M148 (see “Tool table:
Standard tool data” on page 154) and (see “Automatically retract
tool from the contour at an NC stop: M148” on page 256)
„ New powerful function for adjusting the positioning behavior of
rotary axes: FUNCTION TCPM (see “TCPM FUNCTION (Software
Option 2)” on page 480)
„ Conversion of FK programs in conversational programs (see
“Converting FK programs into HEIDENHAIN conversational format”
on page 220)
„ Generation of backward-running programs (see “Generate
Backward Program” on page 485)
„ Displaying messages from the program as explanatory text on the
screen (see “Displaying messages on the TNC screen” on page
525)
„ Show the superimposed window containing all current error
messages (see “List of all current error messages” on page 131)
„ When a program run is interrupted (power failure), the TNC stores
the point of interruption (see “Mid-program startup (block scan)” on
page 569)
„ Search function: New function for replacing all (see “Find/Replace
any text” on page 120)
„ New cycle for face milling (see “FACE MILLING (Cycle 232)” on
page 421)
„ A TURN function for automatic swiveling of the PLANE function was
introduced (see “Automatic positioning: MOVE/TURN/STAY (entry is
mandatory)” on page 473)
„ Feed rate programming: Traversing the programmed path within a
definable time (see “Functions for setting the feed rate” on page
114)
„ Setting the simulation speed during Test Run (see “Setting the
speed of the test run” on page 555)
„ Overwriting empty lines in the tool table (see “Copying a table” on
page 102)
„ Updating TNC software (see “Loading Service Packs” on page 580)
„ Cycle 22 ROUGHING was expanded by a parameter for retraction
feed rate (see “ROUGH-OUT (Cycle 22)” on page 380)
„ Cycle 23 FLOOR FINISHING was expanded by a parameter for
retraction feed rate (see “FLOOR FINISHING (Cycle 23)” on page
381)