HEIDENHAIN iTNC 530 (340 422) - Manual (Page 623)

HEIDENHAIN iTNC 530 623
14.1 Gener
a
l User P
a
ra
met
e
rs
Error message during cycle call MP7441
Error message when M3/M4 not active: 0
Suppress error message when M3/M4 not active: +1
Reserved: +2
Suppress error message when positive depth programmed: +0
Output error message when negative depth programmed: +4
M function for spindle orientation in the
fixed cycles MP7442
Function inactive: 0
Orientation directly through the NC: -1
M function for orienting the spindle: 1 to 999
Maximum contouring speed at feed rate
override setting of 100% in the Program Run
modes MP7470
0 to 99 999 [mm/min]
Feed rate for rotary-axis compensation
movements MP7471
0 to 99 999 [mm/min]
Compatibility machine parameters for
datum tables MP7475
Datum shifts are referenced to the workpiece datum: 0
If the value 1 was entered in older TNC controls or in controls with
software 340 420-xx, datum shifts were referenced to the machine datum.
This function is no longer available. You must now use the preset table
instead of datum tables referenced to REF (see “Datum management with
the preset table” on page 66).
Machining and program run