HEIDENHAIN iTNC 530 (340 422) - Manual (Page 656)

M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Reset M109/M110 „
„
„
page 250
M114
M115 Automatic compensation of machine geometry when working with tilted axes
Reset M114 „
„
page 260
M116
M117 Feed rate for angular axes in mm/minn
Reset M116 „
„
page 257
M118 Superimpose handwheel positioning during program runn „ page 252
M120 Pre-calculate radius-compensated contour (LOOK AHEAD) „ page 250
M124 Do not include points when executing non-compensated line blocks „ page 244
M126
M127 Shortest-path traverse of rotary axes
Reset M126 „
„
page 258
M128
M129 Maintain the position of the tool tip when positioning with tilted axes (TCPM)
Reset M128 „
„
page 261
M130 Moving to position in an untilted coordinate system with a tilted working plane „ page 242
M134
M135 Exact stop at nontangential contour transitions when positioning with rotary axes
Reset M134 „
„
page 263
M136
M137 Feed rate F in millimeters per spindle revolution
Reset M136 „
„
page 249
M138 Select tilting axes „ page 263
M140 Retraction from the contour in the tool-axis direction „ page 253
M141 Suppress touch probe monitoring „ page 254
M142 Delete modal program information „ page 255
M143 Delete basic rotation „ page 255
M144
M145
Compensating the machine’s kinematic configuration for ACTUAL/NOMINAL positions at
end of block
Reset M144 „
„
page 264
M148
M149 Automatically retract tool from the contour at an NC stop
Reset M148 „
„
page 256
M200
M201
M202
M203
M204 Laser cutting: Output programmed voltage directly
Laser cutting: Output voltage as a function of distance
Laser cutting: Output voltage as a function of speed
Laser cutting: Output voltage as a function of time (ramp)
Laser cutting: Output voltage as a function of time (pulse) „
„
„
„
„
page 265
M Effect Effective at block start end Page