HEIDENHAIN iTNC 530 (340 422) - Manual (Page 17)

HEIDENHAIN iTNC 530 17
4.1 Fundamentals ..... 82
Position encoders and reference marks ..... 82
Reference system ..... 82
Reference system on milling machines ..... 83
Polar coordinates ..... 84
Absolute and incremental workpiece positions ..... 85
Setting the datum ..... 86
4.2 File Management: Fundamentals ..... 87
Files ..... 87
Data backup ..... 88
4.3 Standard File Management ..... 89
Note ..... 89
Calling the file manager ..... 89
Selecting a file ..... 90
Deleting a file ..... 90
Copying a file ..... 91
Data transfer to or from an external data medium ..... 92
Selecting one of the last 10 files selected ..... 94
Renaming a file ..... 94
Protecting a file / Canceling file protection ..... 95
4.4 Advanced File Management ..... 96
Note ..... 96
Directories ..... 96
Paths ..... 96
Overview: Functions of the expanded file manager ..... 97
Calling the file manager ..... 98
Selecting drives, directories and files ..... 99
Creating a new directory (only possible on the drive TNC:\) ..... 100
Copying a single file ..... 101
Copying a directory ..... 102
Choosing one of the last 10 files selected ..... 103
Deleting a file ..... 103
Deleting a directory ..... 103
Tagging files ..... 104
Renaming a file ..... 105
Additional functions ..... 105
Data transfer to or from an external data medium ..... 106
Copying files into another directory ..... 108
The TNC in a Network ..... 109
4 Fundamentals of NC, File Management, Programming Aids, Pallet Management ..... 81