HEIDENHAIN iTNC 530 (340 422) - Manual (Page 647)

HEIDENHAIN iTNC 530 647
15.5 Specifics About File Manag
e
ment
15.5 Specifics About File
Management
The iTNC drive
When you call the iTNC file manager, the left window shows all
available drives. For example:
„ C:\ : Windows partition of the built-in hard disk
„ RS232:\ : Serial interface 1
„ RS422:\ : Serial interface 2
„ TNC:\ : Data partition of the iTNC
There might also be other networks available if you have connected
them with Windows Explorer.
If you connect a new network drive with Windows Explorer, you may
have to update the iTNC’s display of available drives:
8 To call the file manager, press the PGM MGT key.
8 Move the highlight to the drive window at left.
8 Switch to the second level of the soft-key row.
8 To update the drive overview, press the UPDATE TREE soft key.
Please note that the data drive of the iTNC appears in the
file manager with the name TNC:\. In Windows Explorer,
this drive (partition) appears with the letter D.
Subdirectories on the TNC drive (e.g. RECYCLER and System
Volume Identifier
) are created by Windows 2000 and
may not be deleted.
With machine parameter 7225 you can define letters of
drives that should not be shown in the file management of
the TNC.
1
2