HEIDENHAIN iTNC 530 (340 422) - Manual (Page 589)

HEIDENHAIN iTNC 530 589
13.6 Ether
n
et Int
e
rf
ace
Network settings specific to the device
8 Press the soft key DEFINE MOUNT to enter the network settings
for a specific device. You can define any number of network
settings, but you can manage only seven at one time.
Setting Meaning
MOUNTDEVICE „ Connection via NFS:
Name of the directory that is to be logged on.
This is formed by the network address of the
server, a colon and the name of the directory
to be mounted. Input: four numerical values
separated by points. Ask your network
specialist for the values, e.g. 160.1.13.4.
Directory of the NFS server that you wish to
connect to the TNC. Be sure to differentiate
between small and capital letters when
entering the path.
„ Connection via smb:
Enter the network name and the share name
of the computer, e.g. //PC1791NT/C
MOUNTPOINT Name that the TNC shows in the file manager
for a connected device. Remember that the
name must end with a colon.
FILESYSTEM-
TYPE File system type.
nfs:
Network File System
smb: Server Message Block (Windows
protocol)
OPTIONS for
FILESYSTEM-
TYPE=nfs Data without spaces, separated by commas,
and written in sequence. Switch between
upper and lower case letters.
rsize=:
Packet size in bytes for data reception.
Input range: 512 to 8192
wsize=:
Packet size in bytes for data
transmission. Input range: 512 to 8192
time0=:
Time, in tenths of a second, after
which the TNC repeats a Remote Procedure
Call. Input range: 0 to 100 000. If there is no
entry, the standard value 7 is used. Use higher
values only if the TNC must communicate with
the server through several routers. Ask your
network specialist for the proper value.
soft=:
Definition of whether the TNC should
repeat the Remote Procedure Call until the NFS
server answers.
“soft” entered: Do not repeat the Remote
Procedure Call.
“soft” not entered: Always repeat the Remote
Procedure Call.