beautypg.com

HEIDENHAIN TNC 426 (280 476) Pilot User Manual

Page 90

background image

91

Digitizing

P: PP.INT = Probe point interval

L: L.SPAC = Line spacing

Digitizing Cycle MEANDER (16)

Cycle 16 MEANDER is for digitizing a 3D contour in a series of

back-and-forth line movements.

Define Cycle 5 RANGE or 15 RANGE

TOUCH PROBE: Select Cycle 16 MEANDER

Line direction: Coordinate axis in whose positive direction the

probe moves after touching the first contour point

Scanning angle: Direction of touch probe traverse relative to

the axis entered in line direction

Feed rate F: Maximum digitizing feed rate

Min. feed rate: Feed rate for scanning the first line

Feed rate reduction at edges: Distance at which the TNC begins to

reduce the scanning feed rate before steep edges

Min. line spacing: Minimum distance moved forward to start the

next line at steep surfaces

Line spacing: Max. distance moved forward to start the next line

Max. probe point interval

Tolerance value: The TNC suppresses the storage of probe points

whose distance from a straight line defined by the last two stored

points is less than the tolerance value.

• The line spacing and max. probe point interval cannot exceed

20 mm!

• Set a line direction that is as perpendicular as possible

to steep surfaces!

7 TCH PROBE 16.0 MEANDER
8 TCH PROBE 16.1 DIRECTN X ANGLE: +0
9 TCH PROBE 16.2 F1500 FMIN 500 MIN.L.SPAC:0.2

L.SPAC:0.5 PP.INT:0.5 TOL:0.1 DIST 0.5