HEIDENHAIN TNC 426 (280 476) Pilot - Manual (Page 100)

101
ISO
Programming
Q Parameter Functions
D00 Assign a value directly
D01 Calculate and assign the sum of two values
D02
Calculate and assign the difference of two values
D03
Calculate and assign the product of two values
D04 Calculate and assign the quotient of two values
D05 Calculate and assign the root from a value
D06
Calculate and assign the sine of an angle in
degrees
D07 Calculate and assign the cosine of an angle in
degrees
D08 Calculate and assign the square root of the sum of
two squares (Pythagorean theorem)
D09 If equal, jump to the given label
D10 If not equal, jump to the given label
D11
If greater than, jump to the given label
D12 If less than, jump to the given label
D13 Find and assign an angle from the arc tangent of
two sides or from the sine and cosine of an angle
D14 Output text to screen
D15 Output text or parameter contents through the
data interface
D19 Transfer numerical values or Q parameters
to the PLC