HEIDENHAIN TNC 320 (77185x-01) Cycle programming - Manual (Page 366)

Touch Probe Cycles: Automatic Workpiece Inspection
16.1 Fundamentals
16
366
TNC 320 | User's Manual Cycle Programming | 3/2014
16.1 Fundamentals
Overview
When running touch probe cycles, Cycle 8 MIRROR
IMAGE, Cycle 11 SCALING and Cycle 26 AXIS-
SPECIFIC SCALING must not be active.
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe.
Refer to your machine manual.
The TNC offers twelve cycles for measuring workpieces
automatically.
Cycle Soft key Page
0 REFERENCE PLANE
Measuring a coordinate in a
selectable axis 372
1 POLAR DATUM PLANE
Measuring a point in a probing
direction 373
420 MEASURE ANGLE
Measuring an angle in the working
plane 374
421 MEASURE HOLE
Measuring the position and diameter
of a hole 377
422 MEASURE CIRCLE OUTSIDE
Measuring the position and diameter
of a circular stud 380
423 MEASURE RECTANGLE INSIDE
Measuring the position, length and
width of a rectangular pocket 383
424 MEASURE RECTANGLE
OUTSIDE
Measuring the position, length and
width of a rectangular stud 386
425 MEASURE INSIDE WIDTH
(2nd soft-key level) Measuring slot
width 389
426 MEASURE RIDGE WIDTH
(2nd soft-key row) Measuring the
width of a ridge 392