HEIDENHAIN TNC 320 (77185x-01) Cycle programming - Manual (Page 278)

Cycles: Special Functions
12.6 ENGRAVING (Cycle 225, DIN/ISO: G225)
12
278
TNC 320 | User's Manual Cycle Programming | 3/2014
Allowed engraving characters
The following special characters are allowed in addition to
lowercase letters, uppercase letters and numbers:
! # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] _
The TNC uses the special characters
% and \
for special functions. These characters must be
indicated twice in the text to be engraved (e.g.
%%) if
you want to engrave them.
You can also use the engraving cycle to engrave German umlauts
and the diameter symbol:
Algebraic sign Input
m %ae
ö %oe
ü %ue
Ä %AE
Ö %OE
Ü %UE
ø %D
Characters that cannot be printed
Apart from text, you can also define certain non-printable
characters for formatting purposes. Enter the special character
\
before the non-printable characters.
The following formatting possibilities are available:
\n: Line break
\t: Horizontal tab (the tab width is permanently set to 8
characters)
\t: Vertical tab (the tab width is permanently set to one line)