HEIDENHAIN TNC 320 (77185x-01) Cycle programming - Manual (Page 31)

TNC 320 | User's Manual Cycle Programming | 3/2014
31
15 Touch Probe Cycles: Automatic Datum Setting........................................................................ 311
15.1 Fundamentals...................................................................................................................................... 312
Overview............................................................................................................................................... 312
Characteristics common to all touch probe cycles for datum setting...................................................314
15.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408).........................................................................316
Cycle run............................................................................................................................................... 316
Please note while programming:.......................................................................................................... 317
Cycle parameters.................................................................................................................................. 318
15.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409).......................................................................320
Cycle run............................................................................................................................................... 320
Please note while programming:.......................................................................................................... 320
Cycle parameters.................................................................................................................................. 321
15.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410).............................................. 323
Cycle run............................................................................................................................................... 323
Please note while programming:.......................................................................................................... 324
Cycle parameters.................................................................................................................................. 325
15.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411).......................................... 327
Cycle run............................................................................................................................................... 327
Please note while programming:.......................................................................................................... 327
Cycle parameters.................................................................................................................................. 328
15.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412)...................................................... 330
Cycle run............................................................................................................................................... 330
Please note while programming:.......................................................................................................... 331
Cycle parameters.................................................................................................................................. 332
15.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413).................................................. 335
Cycle run............................................................................................................................................... 335
Please note while programming:.......................................................................................................... 335
Cycle parameters.................................................................................................................................. 336
15.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414)................................................339
Cycle run............................................................................................................................................... 339
Please note while programming:.......................................................................................................... 340
Cycle parameters.................................................................................................................................. 341