HEIDENHAIN TNC 320 (77185x-01) Cycle programming User Manual
Page 22
Contents
22
TNC 320 | User's Manual Cycle Programming | 3/2014
7.9
CONTOUR TRAIN (Cycle 25, DIN/ISO: G125)...................................................................................184
Cycle run............................................................................................................................................... 184
Please note while programming:.......................................................................................................... 184
Cycle parameters.................................................................................................................................. 185
7.10 TROCHOIDAL SLOT (Cycle 275, DIN ISO G275)............................................................................... 186
Cycle run............................................................................................................................................... 186
Please note while programming:.......................................................................................................... 187
Cycle parameters.................................................................................................................................. 188
7.11 Programming Examples..................................................................................................................... 190
Example: Roughing-out and fine-roughing a pocket............................................................................. 190
Example: Pilot drilling, roughing-out and finishing overlapping contours.............................................. 192
Example: Contour train......................................................................................................................... 194