HEIDENHAIN TNC 320 (77185x-01) Cycle programming User Manual

Page 21

TNC 320 | User's Manual Cycle Programming | 3/2014

Fixed Cycles: Contour Pocket......................................................................................................167

7.1

SL Cycles..............................................................................................................................................168

Fundamentals........................................................................................................................................ 168

Overview............................................................................................................................................... 169

7.2

CONTOUR (Cycle 14, DIN/ISO: G37).................................................................................................170

Please note while programming:.......................................................................................................... 170

Cycle parameters.................................................................................................................................. 170

7.3

Superimposed contours..................................................................................................................... 171

Fundamentals........................................................................................................................................ 171

Subprograms: overlapping pockets....................................................................................................... 171

Area of inclusion................................................................................................................................... 172

Area of exclusion.................................................................................................................................. 172

Area of intersection.............................................................................................................................. 173

7.4

CONTOUR DATA (Cycle 20, DIN/ISO: G120).....................................................................................174

Please note while programming:.......................................................................................................... 174

Cycle parameters.................................................................................................................................. 175

7.5

PILOT DRILLING (Cycle 21, DIN/ISO: G121)..................................................................................... 176

Cycle run............................................................................................................................................... 176

Please note while programming:.......................................................................................................... 176

Cycle parameters.................................................................................................................................. 177

7.6

ROUGHING (Cycle 22, DIN/ISO: G122)............................................................................................. 178

Cycle run............................................................................................................................................... 178

Please note while programming:.......................................................................................................... 179

Cycle parameters.................................................................................................................................. 180

7.7

FLOOR FINISHING (Cycle 23, DIN/ISO: G123)..................................................................................181

Cycle run............................................................................................................................................... 181

Please note while programming:.......................................................................................................... 181

Cycle parameters.................................................................................................................................. 181

7.8

SIDE FINISHING (Cycle 24, DIN/ISO: G124)..................................................................................... 182

Cycle run............................................................................................................................................... 182

Please note while programming:.......................................................................................................... 182

Cycle parameters.................................................................................................................................. 183