4 d a tu m set ting (without a 3-d t ouc h pr obe) – HEIDENHAIN TNC 320 (340 55x-03) User Manual

Page 58

2 Manual Operation and Setup

2.4 D

m Set

ting (Without a 3-D T

ouc

h Pr

obe)

Editing the preset table

Editing function in table mode

Soft key

Select beginning of table

Select end of table

Select previous page in table

Select next page in table

Select the functions for preset entry

Display Basic Transformation/Axis Offset
selection

Activate the datum of the selected line of the
preset table

Add the entered number of lines to the end of the
table (2nd soft-key row)

Copy the highlighted field (2nd soft-key row)

Insert the copied field (2nd soft-key row)

Reset the selected line: The TNC enters – in all
columns (2nd soft-key row)

Insert a single line at the end of the table
(2nd soft-key row)

Delete a single line at the end of the table
(2nd soft-key row)