HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 436)

436 10 Programming: Q-Parameters
1
0
.12 Pr
eassigned Q P
a
ra
met
e
rs
Coordinates after probing during program run
The parameters Q115 to Q119 contain the coordinates of the spindle
position at the moment of contact during programmed measurement
with the 3-D touch probe. The coordinates refer to the datum point
that is active in the Manual operating mode.
The length of the stylus and the radius of the ball tip are not
compensated in these coordinates.
Coordinate axis Parameter value
X axis Q115
Y axis Q116
Z axis Q117
4th axis
Machine-dependent Q118
5th axis
Machine-dependent Q119