HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 108)

108 4 Programming: Fundamentals of NC, File Management, Programming Aids
4.7 A
dding Comments
4.7 Adding Comments
Function
You can add comments to a part program to explain program steps or
make general notes.
Adding a comment line
 Select the block after which the comment is to be inserted.
 Press the SPEC FCT key to select the special functions.
 Press the INSERT COMMENT soft key.
 Enter your comment using the screen keyboard (See “Screen
keypad” on page 79)
Functions for editing of the comment
If the TNC cannot show the entire comment on the
screen, the >> sign is displayed.
Function Soft key
Jump to beginning of comment.
Jump to end of comment.
Jump to the beginning of a word. Words must be
separated by a space.
Jump to the end of a word. Words must be
separated by a space.
Switch between insert mode and overwrite
mode.