HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 214)

214 8 Programming: Cycles
8.2 Cy
cles f
o
r Dr
illing, T
a
pping and Thr
ead Milling
262 THREAD MILLING
Cycle for milling a thread in pre-drilled
material 242
263 THREAD MILLING/CNTSNKG
Cycle for milling a thread in pre-drilled
material and machining a countersunk
chamfer 244
264 THREAD DRILLING/MILLING
Cycle for drilling into the solid material
with subsequent milling of the thread
with a tool 248
265 HEL.THREAD DRILLING/MILLING
Cycle for milling the thread into the solid
material 252
267 OUTSIDE THREAD MLLNG
Cycle for milling an external thread and
machining a countersunk chamfer 256
Cycle Soft key Page