HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 435)

HEIDENHAIN TNC 320 435
1
0
.12 Pr
eassigned Q P
a
ra
met
e
rs
Spindle status: Q110
The value of the parameter Q110 depends on the M function last
programmed for the spindle.
Coolant on/off: Q111
Overlap factor: Q112
The overlap factor for pocket milling (MP7430) is assigned to Q112.
Unit of measurement for dimensions in the
program: Q113
During nesting the PGM CALL, the value of the parameter Q113
depends on the dimensional data of the program from which the other
programs are called.
Tool length: Q114
The current value for the tool length is assigned to Q114.
M function Parameter value
No spindle status defined Q110 = –1
M03: Spindle ON, clockwise Q110 = 0
M04: Spindle ON, counterclockwise Q110 = 1
M05 after M03 Q110 = 2
M05 after M04 Q110 = 3
M function Parameter value
M08: Coolant ON Q111 = 1
M09: Coolant OFF Q111 = 0
Dimensional data of the main program Parameter value
Metric system (mm) Q113 = 0
Inch system (inches) Q113 = 1