7 optional block skip, Function, Inserting the “/” character – HEIDENHAIN TNC 320 (340 55x-03) User Manual

Page 465: Erasing the “/” character, 7 optional bloc k skip 11.7 optional block skip

HEIDENHAIN TNC 320

465

.7 Optional Bloc

k Skip

11.7 Optional Block Skip

Function

In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:



To run or test the program without the blocks

preceded by a slash, set the soft key to ON.



To run or test the program with the blocks preceded

by a slash, set the soft key to OFF.

Inserting the “/” character



In the Programming mode you select the block in which the character
is to be inserted.



Select the SHOW BLOCK soft key.

Erasing the “/” character



In the Programming mode you select the block in which the character
is to be deleted.



Select the SHOW BLOCK soft key.

This function does not work for TOOL DEF blocks.

After a power interruption the control returns to the most
recently selected setting.