HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 213)

HEIDENHAIN TNC 320 213
8.2 Cy
cles f
o
r Dr
illing, T
a
pping and Thr
ead Milling
8.2 Cycles for Drilling, Tapping and
Thread Milling
Overview
Cycle Soft key Page
240 CENTERING
With automatic pre-positioning,
2nd set-up clearance, optional entry of
the centering diameter or centering
depth 215
200 DRILLING
With automatic pre-positioning,
2nd set-up clearance 217
201 REAMING
With automatic pre-positioning,
2nd set-up clearance 219
202 BORING
With automatic pre-positioning,
2nd set-up clearance 221
203 UNIVERSAL DRILLING
With automatic pre-positioning, 2nd set-
up clearance, chip breaking, and
decrementing 223
204 BACK BORING
With automatic pre-positioning,
2nd set-up clearance 225
205 UNIVERSAL PECKING
With automatic pre-positioning,
2nd set-up clearance, chip breaking, and
advanced stop distance 228
208 BORE MILLING
With automatic pre-positioning,
2nd set-up clearance 231
206 TAPPING NEW
With a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance 233
207 RIGID TAPPING NEW
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance 235
209 TAPPING W/ CHIP BREAKING
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance, chip breaking 237