HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 362)

362 9 Programming: Subprograms and Program Section Repeats
9.1 Labeling Subpr
ogr
ams and Pr
ogr
am Section Repeats
9.1 Labeling Subprograms and
Program Section Repeats
Subprograms and program section repeats enable you to program a
machining sequence once and then run it as often as desired.
Labels
The beginnings of subprograms and program section repeats are
marked in a part program by labels (LBL).
A LABEL is identified by a number between 1 and 65 534 or by a name
you define. Each LABEL number or LABEL name can be set only once
in the program with LABEL SET. The number of label names you can
enter is only limited by the internal memory.
LABEL 0 (LBL 0) is used exclusively to mark the end of a subprogram
and can therefore be used as often as desired.
Do not use a label number or label name more than once!