HEIDENHAIN ND 710 v.3 - Manual (Page 43)

44
Multipoint
A
xis
Error
Compensation
Z
AXIS X
Select the compensation-value table
(e.g., for the Z axis), and delete the table.
DELETE Z
Confirm with ENT, or cancel with CL.
ENT
Conclude entry.
Deleting a compensation table
PARAMETER
Select the dialog for entering the code
number.
CODE
Enter the code number 105296 and
confirm with ENT.
1 0 5 2
9 6 ENT
SPEC
FCT
Select “parameter.”
SPEC
FCT
ENT
SPEC
FCT
or
28.024
Enter all further compensation points. If
you press the minus key, the number of
the current compensation point will be
shown in the X display.
Direct selection of compensation
points: Press the minus key together
with the number (two-digit) of the
desired compensation point.
Conclude entry.
ENT
SPEC
FCT
or
CL
Select the special functions.
Bateil2.pm6 27.03.2002, 11:33 44