HEIDENHAIN ND 710 v.3 - Manual (Page 17)

17
Datum Setting
Touch workpiece at position 1 with the
tool.
Touch workpiece at position 2 with the
tool.
ENT
PROBE CIRC.
1ST POS X (appears only briefly)
2ND POS X
(appears only briefly)
•
•
•
Confirm “Probe circle.”
Touch workpiece at position 3 with the
tool.
3RD POS Y (appears only briefly)
ENT
Position 1 is captured.
Retract tool from workpiece.
ENT
Retract tool from workpiece.
Position 2 is captured.
ENT
Retract tool from workpiece.
Position 3 is captured.
•
•
•
Bateil1.pm6 07.11.2001, 09:38 17