HEIDENHAIN ND 710 v.3 - Manual (Page 18)

18
2 6
Enter position value for the X coordinate
of circle center, e.g. 26. “CENTER Y”
appears briefly. Status display SET starts
to blink in the Y axis.
Exit the probing functions.
ENT
SPEC
FCT
CL
or
Touch workpiece at position 4 with
the tool.
4TH POS Y
(appears only briefly)
Enter position value for the Y coordinate
of circle center, e.g. 0.
0
ENT
ENT
Position 4 is captured. “CENTER X”
appears briefly. Status display SET
starts to blink in the X axis.
Datum Setting
Bateil1.pm6 07.11.2001, 09:38 18