HEIDENHAIN ND 710 v.3 - Manual (Page 20)

20
Moving
the
Axes
w
ith
Distance-To-Go
D
isplay
Select the special functions.
Moving the Axes with Distance-To-Go Display
Normally, the display shows the actual position of the tool. However, it
is often more helpful to display the distance remaining to the nominal
position (the distance-to-go). You can then position simply by moving
the axis until the display value is zero.
You can enter the absolute coordinates in the distance-to-go display.
An active radius compensation will be considered.
Example: Milling a shoulder with distance-to-go
R + -
Select the axis, enter the nominal value,
e.g. 20 mm, select radius compensation R+,
confirm with ENT.
ENT
Y 0 2
Confirm your selection, the D symbol lights.
ENT
DELTA MODE
SPEC
FCT
•
•
•
Select “delta mode.” SPEC
FCT
or
Bateil1.pm6 07.11.2001, 09:38 20