HEIDENHAIN ND 710 v.3 - Manual (Page 12)

12
Datum Setting
Select the special functions.
SPEC
FCT
PROBE EDGE
ENT
Confirm “Probe edge.”
•
•
•
X
Select the X axis (if not already selected).
SET lights. The ❘<- status symbol starts
to blink.
ENT
X position is captured. “SET edge“
appears briefly. SET starts to blink.
Retract tool from workpiece.
The ❘<- status symbol lights.
Enter position value for the datum.
Tool radius is automatically
compensated.
0
Y
Select the Y axis. SET lights.
The ❘<- status symbol starts to blink.
ENT
•
•
Select the “probing function.”
PROBING
ENT
Confirm selection.
SPEC
FCT
•
•
Touch workpiece edge 1 with the tool.
PROBE X
(appears only briefly))
Touch workpiece edge 2 with the tool.
PROBE Y
(appears only briefly)
or
Select a datum number (see
page 10).
Probing a workpiece edge to find a datum
Bateil1.pm6 07.11.2001, 09:38 12