HEIDENHAIN ND 710 v.3 - Manual (Page 42)

43
Multipoint
A
xis
Error
Compensation
Selecting the compensation table, entering an axis correction
DATUM X
Enter the active datum for the error on
the axis to be corrected (e.g. 27 mm)
and confirm with ENT.
2 7
SPACING X
Enter the spacing of the compensation
points on the axis to be corrected, for
example 2 10 mm (equals 1.024 mm), and
confirm with ENT.
1 0
27.000
Compensation point no. 1 is displayed.
Enter the associated compensation
value (e.g. 0.01 mm) and confirm with
ENT.
0
0 1
Select the special functions.
PARAMETER
Select the dialog for entering the code
number.
CODE
Enter code number 105296 and
confirm with ENT.
1 0 5 2
9 6 ENT
X
AXIS X
Select the axis to be corrected (e.g. X),
and confirm with ENT.
X FCT. X
Enter the axis causing the error (e.g. X)
(screw pitch error), and confirm with
ENT.
•
•
X
SPEC
FCT
ENT
ENT
ENT
ENT
ENT
ENT
Select "parameter" (if required) by
repeatedly pressing the 1 2 key.
SPEC
FCT
ENT
or
•
•
Bateil2.pm6 27.03.2002, 11:33 43