Polaris 2016 Victory Cross Country - Manual (Page 86)

84
Maintenance
Seat Removal / Installation
1. Remove the side covers. See page 80.
2. Remove the two seat screws.
Tool: 6 mm Allen wrench
3. Lift the front of the seat upward and pull
forward to disengage the tab at the rear of
the seat. If equipped, unplug the seat
heater.
4. To install, reverse the above process, being
sure to engage the tab at the back of the
seat.
5. Tighten the seat screws.
Torque: 10 ft-lbs (13.5 Nm)
Headlight Aim Inspection (Halogen)
The top edge of the high beam must be
3 inches (7.6 cm) below the widest part
of the headlight and centered straight
ahead at 25 feet (7.6 m).
1. Verify that tire pressure is at
specification. See page 75.
2. Verify that rear suspension ride
height (preload) is at specification.
See page 64.
3. Position the motorcycle on a level
surface with the headlight 25 feet
(7.6 m) from a wall.
4. With the operator and passenger (if
applicable) on board, bring the
motorcycle to the fully upright
position.
5. Move the ignition switch to the ON position and switch the headlamp to high beam.
Observe the headlight aim on the wall.
6. Make any necessary adjustments to headlight aim. See page 85.
Seat Screws
10 ft-lbs (13.5 Nm)
25 ft. (7.6 m)
Height of widest part
of headlight
3 in. (7.6 cm)
Low Beam