Polaris 2016 Victory Cross Country - Manual (Page 84)

82
Maintenance
Saddlebag Removal (Without Audio)
1. Open the saddlebag cover. Rotate the two fasteners 1/4 turn counter-clockwise.
2. Slightly pivot the saddlebag away from the motorcycle. Close the saddlebag cover.
3. Disconnect any wire harnesses leading from the saddlebag to the motorcycle. If
necessary, remove the seat.
4. Grasp the base of the bin with both hands and gently lift the saddlebag away from the
motorcycle. Use care to avoid scratching the saddlebag or the motorcycle.
5. Place the saddlebag in a safe location to prevent damage.
Saddlebag Installation (Without Audio)
1. Gently position the saddlebag onto the
pads on the exhaust pipe, aligning the
1/4-turn fasteners with the receptacles.
2. Reconnect any wire harnesses. Use
care to avoid scratching the saddlebag
or the motorcycle.
3. Open the saddlebag cover. Make sure
the 1/4-turn fastener rings are in the
unlatched (vertical) position.
4. While gently pushing the saddlebag
downward and toward the motorcycle,
push each fastener inward until the
retaining spring wire is captured by the
fastener pin. While pushing a fastener
inward, slightly rotate it both
clockwise and counter-clockwise to
help engage the spring. When the
spring is engaged, rotate the fastener
clockwise until you feel the latch click
(about 1/4 turn). The fastener ring
should be in a generally horizontal
position when latched.
5. Close the saddlebag cover.
Vertical Rings (Unlatched)
Spring Pin