Polaris 2016 Victory Cross Country - Manual (Page 42)

40
Pre-Ride Inspections
Front Suspension
Inspect the front forks for oil leaks or damage, and verify smooth suspension operation. See
page 66.
Steering
1. On level ground, straddle the motorcycle and bring it to the fully upright position. Turn
the handlebars from stop to stop. The action should be smooth, but not loose.
2. Make sure wires, hoses and control cables do not interfere with smooth steering.
Rear Suspension
1. Check rear shock absorber movement and air pressure to ensure the correct amount of
suspension travel and ground clearance.
2. For air pressure adjustment information, see page 64 or refer to the suspension air
pressure label located in the left saddlebag near the air fitting.
WARNING! Inadequate ground clearance could result in components contacting the ground, causing
loss of control and serious injury or death. Always ensure ground clearance is at specification.
Drive Belt
1. Check drive belt tension. See page 61. The
drive belt should fit tightly.
Tip: The drive belt system must be cool, clean and dry to
accurately measure belt tension (deflection). Do not
measure belt tension when the belt or drive system
is wet, or when it is hot (such as immediately after
riding).
2. Check the drive belt teeth for stones or other
debris.
3. Inspect drive belt condition. If you discover
cracks, broken teeth or frayed edges, replace
the drive belt before riding. See the VICTORY
Service Manual or an authorized VICTORY
dealer.
Drive Belt