Polaris 2016 Victory Cross Country - Manual (Page 66)

64
Maintenance
Rear Suspension Adjustment
For riding comfort and to ensure proper ground
clearance, adjust rear shock air pressure as specified on
the label located in the right saddlebag cover (reproduced
below).
Follow these guidelines when adjusting:
• Park the motorcycle with the sidestand down on a
firm, level surface. Remove all riders and cargo.
• DO NOT exceed 72 PSI (496 kPa) in the shock.
• Use the VICTORY Air Pump and Gauge (P/N
2876654). Follow the instructions on the following
pages.
If the VICTORY air pump and gauge are not available, use the gauge provided in the tool kit,
and a pressurized air source with a maximum line pressure of 72 PSI (496 kPa). After using
this gauge, remove it quickly to minimize leakage. Expect to lose about 4 PSI (27.6 kPa)
with each pressure check when using this gauge. Use only a dry air source, such as a system
with a water separator or air line dryer, to prevent moisture from entering the shock.
CAUTION! Air pressure increases VERY quickly when using pressurized air. Wear eye and face
protection.
Air Suspension Adjustment
(Shock Label)
Set desired pressure with bike unloaded on side stand
Total Cargo
& Occupant
Weight (lbs)
Air Pressure (PSI) - MAX 72 PSI
No Trunk Trunk ABS-Tour Low
(MAGNUM)
100 0 0 0 26
125 0 0 0 30
150 0 0 9 35
175 0 9 15 38
200 0 15 25 42
225 9 25 29 46
250 15 29 34 49
275 25 34 39 52
300 29 39 45 57
325 34 45 52 63
350 39 52 58 65
375 45 58 65 68
400 52 65 70 72
425 58 70 72
450 65 72 72
475 70 72 72
500 72 72 72
Shock Label