beautypg.com

Pre-ride inspections – Polaris 2016 Victory Cross Country User Manual

Page 37

background image

35

Pre-Ride Inspections

Turn the ignition key to the ON position and move the stop/run switch to RUN before
performing the following electrical inspections. Return the ignition key to the OFF position
after completing these inspections. If inspection of any electrical item reveals component
failure, repair or replace the component before operating the motorcycle.

Item

Inspection Procedure

Electrical

Headlamp

Switch to high beam. Verify that the high beam indicator comes on and that
lamp brightness increases.

Taillight/Brakelight

Verify that the taillight and license plate light illuminate. Verify that the taillight
lamps increase in brightness when the front brake lever is applied and also
when the rear brake pedal is applied.

Turn Signals

Move the turn signal switch to the left. Verify that front and rear left turn signals
flash, as well as the corresponding light on the indicator panel. Push the switch
inward to cancel the signal. Verify that the signals and the indicator light stop
flashing. Repeat the procedure for the right turn signals.

Emergency Flashers Press the top of the hazard switch to turn the flashers on. Verify that all four

turn signals flash, as well as the lamps on the indicator panel. Turn the flashers
off. Verify that all signals and indicator lamps stop flashing.

Horn

Press the horn button. Verify that the horn sounds loudly.

Neutral Indicator

Place the transmission in neutral. Verify that the neutral indicator lamp
illuminates and that the letter “N” displays in the gear position display.

Low Oil Pressure
Indicator

Verify that the low oil pressure lamp illuminates. Start the engine and verify that
the low oil pressure lamp goes off.

Engine Stop/Run
Switch

Start the engine. Move the stop/run switch to the STOP position. Verify that the
engine stops. Attempt to restart the engine to verify that the engine WILL NOT
start.

General

Engine Oil Level

Check the oil level on the dipstick.

Fuel Level

View the fuel gauge or information bar.

Tires

Inspect condition, pressure and tread depth.

Brake Operation

Inspect pedal and lever movement.

Brake Fluid Levels

Check front and rear brake fluid levels.

Brake Components

Inspect hoses, connections, brake pads.

Throttle

Inspect hand grip and throttle freeplay.

Clutch (Mechanical)

Check lever operation and freeplay.

Front Suspension

Check for leaks, debris and damage.

Steering

Check for smooth operation.

Rear Suspension

Check shock movement and air pressure, verify ground clearance.

Drive Belt

Check for wear, damage, proper deflection.

Sidestand

Verify smooth operation, inspect pivot bolt, spring and pad.

Fasteners

Inspect for loose, damaged or missing fasteners.

Mirrors

Adjust for proper rear view.

This manual is related to the following products: