Polaris 2016 Victory Cross Country - Manual (Page 123)

121
Cross Country/Cross Country Tour Audio System
CB Radio / ICOM System
ICOM System
Press and release
ICOM on the left
control to activate
the intercom
system.
When the
intercom system is active, ICOM will
display on the console screen.
VOX Break Setting
The intercom is opened and closed using a
voice-operated switch (VOX). The volume
sensitivity level required to open the
intercom can be adjusted using the VOX
sensitivity setting.
Press and hold
ICOM on the
upper left control
to access the VOX
sensitivity set
screen.
Push COM or ICOM to adjust the
sensitivity setting.
Tip: Lower settings require less volume to open
the intercom. If wind or ambient vehicle
noise trigger the VOX to open, set the VOX
sensitivity to a higher level.
“VOX” will display on the console screen
whenever the driver or passenger are
communicating over the intercom system.
Driver ICOM Volume
To change settings, enter the mode menu.
Press TUNE (+) or TUNE (-) to adjust
settings.
Tip: Intercom volume can also be adjusted with
the hand control when the VOX circuit is
open.
Passenger ICOM Volume
Press (+) or (-) on the headset control to
raise or lower volume.
Headset Receptacles
The driver's headset receptacle is located on
the left side of the motorcycle below the
fuel tank.
The passenger headset receptacle (if
equipped) is located on the left side of the
motorcycle on the forward side of the
saddlebag.
FM
ICOM
CB19
92.5
COM
+/-
ICOM
VOX 15
100.5
FM
VOX
CB19
+
TUNE
-
ICOM VOL 15