Grass Valley Profile CD-ROM Drive - Manual (Page 45)

Installing the Windows NT CD-ROM Driver
CD-ROM Instructions 45
8. Select Other in the drop down list of drivers.
9. When the Insert Disk dialog box appears, insert the NT Driver Diskette in the
PDR100 floppy drive and then click OK .
10. Select the F.I.T. Parallel-Port Trans-Series NT Driver , then click OK .
11. When the Select SCSI Adapter Option dialog box appears, verify that F.I.T. is
selected and then click Install .
12. When Windows NT Setup dialog box appears verify path is A:\ , then chose
Continue.
13. Chose Close .
14. Remove the NT Driver Diskette and then shutdown and restart Windows NT.
Logon as Administrator.
NOTE: The message, “At least one service or driver failed during
start-up” displayed during start-up, may indicate a parallel port
problem. Refer to “PDR100 Troubleshooting” on page 49.
15. Open File Manager and verify that the CD-ROM drive is listed as a drive. If the
CD-ROM drive doesn’t appear, refer to “PDR100 Troubleshooting” on
page 49 to help find the cause.
If the CD-ROM drive does appear, you have successfully installed the
CD-ROM drive for use with Windows NT 3.51 on your PDR100.
NOTE: The CD-ROM drive is not intended to be a permanent part of
the Profile system. Remove the CD-ROM drive when it is no longer
needed using the instructions in “Removing the CD-ROM Drive” on
page 47.
Installing the CD-ROM Driver in Windows NT 4.0
To install the CD-ROM driver in Windows NT 4.0:
1. Power up the PDR100 and logon as administrator using these steps:
a. Hold the Shift key down during start-up to prevent auto-logon as user
profile. Be sure to hold down the shift key until the logon dialog box
appears.
b. Logon as administrator. The factory default administrator password on a
PDR100 is triton.