Grass Valley Profile CD-ROM Drive - Manual (Page 17)

General Installation Instructions
CD-ROM Instructions 17
General Installation Instructions
The Profile system can be configured when fully extended on the rack slides if the
equipment rack is adequately mounted to prevent tipping, and if there is sufficient
slack in the cables connected to the rear panel to allow the cabinet to fully extend
on the slides.
WARNING: Unless the equipment rack is adequately anchored, the rack
could tip when the cabinet is extended on the rack slides. To avoid possible
injury, make sure the rack is firmly anchored before extending the cabinet on
the rack slides.
If it is necessary for you to remove the Profile system from the equipment rack to
perform this installation, refer to the system’s Installation Manual for instructions.
CAUTION: The video disk recorder contains components that are highly
sensitive to electrostatic discharge. To protect these components from
damage and to maintain product reliability, take the following precautions
when handling the circuit boards:
• Handle all circuit boards in a static-protected area capable of controlling
static charge on conductive materials, people, and non-conductive
materials. Static-protected areas include non-static table tops and
non-static floor mats.
• Handle circuit boards only by the edges. Avoid touching the printed wires
on the back of the circuit board as much as possible.
!!
!!