Grass Valley Profile CD-ROM Drive - Manual (Page 34)

PDR100 Installation
34 CD-ROM Instructions
Verifying Switch Settings On the VGA-I/O Board (if installed)
Some PDR100 units have the VGA-I/O board installed which includes a parallel
port. If this board is installed with the 486 System CPU board, you must make sure
the parallel port on the VGA-I/O board is disabled by verifying the configuration
switch settings. (If you need to determine your System CPU board hardware
version, refer to “Determining the System CPU Board Hardware Version” on
page 29.)
To determine if a VGA-I/O Board is installed and to verify switch settings:
1. Compare your PDR100 to Figure 7,which shows VGA boards with and without
a parallel port. Then do one of the following:
a. If you have a VGA board without a parallel port, proceed with “Installing
the Parallel Port L-bracket” on page 39.
b. If you have a VGA I/O board with a parallel port you must verify the
switch settings by continuing with the next step in this procedure.
Figure 7. PDR100 VGA board with and without a parallel port
9897-2
With
Parallel
Port
Without
Parallel
Port