Grass Valley Profile CD-ROM Drive - Manual (Page 42)

PDR100 Installation
42 CD-ROM Instructions
Connecting the CD-ROM Drive to the PDR100
This section provides instructions for connecting the CD-ROM drive to your
PDR100 system and local power source.
To connect the CD-ROM drive:
1. Shut down your Windows NT session and power off the PDR100.
2. Connect one end of the parallel cable to the CD-ROM drive’s TO COMPUTER
connector and the other end to the parallel port on the PDR100. Table 4 shows
examples of CD-ROM drive parallel port connections for different PDR100
hardware versions.
3. Connect power to the CD-ROM drive using the universal power supply and one
of the four power supply cables provided with the kit.
4. Turn on the CD-ROM drive power switch and power up the PDR100.
Now that your CD-ROM drive is connected to your PDR100, you must install the
Windows NT device driver. The next section describes how to do this.