Grass Valley Profile CD-ROM Drive - Manual (Page 41)

Installing the Parallel Port
CD-ROM Instructions 41
3. Locate your Profile system software version in Table 3, then follow the
instructions listed for your software version.
Now that the PDR100 parallel port is installed and enabled, you are ready to
connect the CD-ROM drive. The next section, “Connecting the CD-ROM Drive to
the PDR100” on page 42, describes how to do this.
Table 3. Procedures to enable parallel port settings in CMOS
IF your Profile software version is THEN perform these instructions
2.0 or higher If Windows NT 3.51:
1. Open PDR Debug Tools program group.
2. Double-click LOAD CMOS icon.
3. Shut down and restart Windows NT, then logon as
Administrator.
If Windows NT 4.0:
1. Select Start | Programs | PDR Debug Tools | Load
CMOS .
2. Shut down and restart Windows NT and then logon as
Administrator.
1.4.15 or higher, but lower than 2.0 1. Place CD-ROM drive NT Driver Diskette in the floppy
disk drive.
2. If Windows NT 3.51, chose Run in the Program
Manager File menu.
If Windows NT 4.0, select Start | Run
3. Type A:\newcmos\loadcmos , then press Enter .
4. Shutdown and restart Windows NT, then logon as
Administrator.
1.4.14 or lower 1. Place CD-ROM drive NT Driver Diskette in the floppy
disk drive.
2. If Windows NT 3.51, chose Run in the Program
Manager File menu.
If Windows NT 4.0, select Start | Run
3. Type A:\oldcmos\loadcmos , then press Enter .
4. Shutdown and restart Windows NT and then, logon as
Administrator.