Grass Valley PDR100 - Manual (Page 75)

Electrical Characteristics
PDR100 Installation A-3
K-Factor Requirement:
≤
1% Direct or AGC Path
2T Pulse-to-Bar Ratio Requirement:
≤
1% Direct or AGC Path
Output Timing Range Requirement: -21/2H to +148H
Supplemental Data:Independent for each output
Supplemental Data:Resolution;
≈
0.3
°
of 3.58 MHz
Supplemental Data:Timing Stability: 1
°
Sync and Burst Insertion
Timing Accuracy Requirement: Meets RS-170A, and CCIR RPT 624-3;
always on
Insertion Phase Error Requirement:
≤
1
°
Direct or AGC Path
Chrominance Phase Error
with Reference Burst
Frequency Change Requirement:
≤
1
°
with an input burst. This is a frequency change
of
±
10 Hz Direct or AGC Path
Chrominance Phase Error
with Reference Signal
Amplitude Change Requirement:
≤
1
°
with a
±
3 dB amplitude change
Direct or AGC Path
DC Offset Requirement:
≤±
50 mV Direct or AGC Path
Inserted Sync and Burst
Amplitude Accuracy Requirement: Sync Direct or AGC Path
NTSC 40 IRE
±
1 IRE
PAL 300 mV
±
7 mV
Burst Direct or AGC Path
NTSC 40 IRE
±
1 IRE
PAL 300 mV
±
7 mV
Inserted Sync and Burst
SCH Phase Accuracy Requirement: 0
° ±
5
°
Direct or AGC Path
Black Level Error Requirement:
±
3.5 mV Direct
±
5 mV AGC Path
Table A-3. Analog Composite Video Output
(
Valid for Customer-Installed Composite Output or Digital Component Input/Analog Composite Output)
Characteristics Description
Program Gain Requirement: 1
±
1%
Frequency Response Requirement: 500 kHz to 5.8 MHz
±
2%
Supplemental Data:-3 dB Nominally 6.25 MHz
Signal-to-Noise Ratio Requirement: > 50 dB
Chrominance-to-Luminance Delay
Error Requirement:
≤
10 ns NTSC
≤
15 ns PAL
Differential Gain Requirement:
≤
1% NTSC
≤
1.5% PAL
Differential Phase Requirement:
≤
1
°
K-Factor Requirement:
≤
1%
2T Pulse-to-Bar Ratio Requirement:
≤
1%
Table A-2. Analog Composite Video E-to-E (Direct) (Continued)
(Valid only for Factory Installed Analog Composite Input/Output)
Characteristics Description