Grass Valley PDR100 - Manual (Page 23)

Analog Composite Two Channels In and Four
PDR100 Installation 2-7
Analog Composite Two Channels In and Four Channels Out
This is Option 43 in the standard factory configurations. This configuration uses two
analog composite inputs and four analog composite outputs. The configuration is
shown with two Disk Recorder circuit boards and a minimum of eight hard disk
drives. See Table 2-2.
Note that there is an Audio circuit board adjacent to each Analog Input circuit boards
for audio input/output. In addition, there are Audio circuit boards in J12 and J13 next
to the Composite Analog Output circuit board to accommodate the third and fourth
audio output channels.
Table 2-2. Circuit Boards for Analog Composite Two-CH In/Four-CH Out
Slot Board Name Dedicated
Location Miscellaneous
J1 Processor Yes EISA & ISA
J2 VGA Yes ISA
J3 Empty —
J4 Decoder No Two board set that must be kept together.
J5 Composite Analog Input No
J6 Audio No Four Audio Channels
J7 Empty —
J8 Decoder No Two board set that must be kept together.
J9 Composite Analog Input No
J10 Audio No Four Audio Channels
J11 Composite Analog Output Yes Requires four video connections at the Video
Router bus
J12 Audio No Four Audio Channels
J13 Audio No Four Audio Channels
J14 Master Disk Recorder Yes Controls four, eight, or twelve hard disks
J15 Slave Disk Recorder Yes Controls four, eight, or twelve hard disks
J16 Reference Genlock Yes
J17 RS-422 I/O Yes