Grass Valley PDR100 - Manual (Page 29)

Mounting the PDR and PDX Units
PDR100 Installation 3-5
Mounting the Slide Tracks in the Rack
Locate the proper rack holes as shown in Figure 3-7. Notice that the hole spacing can
vary with the rack type. When installing the slides in racks with EIA spacing, make
sure that the slides are attached to the 0.5 inch spaced holes.
Mount the rails using the enclosed hardware as shown in Figure 3-6. Figures 3-8 and
3-9 show the front and rear rail mounting details for both deep and shallow racks.
Make sure the stationary sections are horizontally aligned and are level as well as
parallel to each other.
Figure 3-7. Spacing for Mounting Holes in a Standard Rack
1.250 in
(3.18 cm)
MIL STD 189
SPACING
“UNIVERSAL” SPACING
EIA RS310, RETMA
0.500 in
(1.27 cm)
0.625 in
(1.59 cm)
1.250 in
(3.18 cm)
1.250 in
(3.18 cm)
0.625 in
(1.59 cm)